Benelli/Beretta Flat Circle Dot Sight Post - Tritium Dot, Green Circle, w/ Hood
The Blitzkrieg Components Tritium Flat-Tipped Circle-Dot Sight Post provides a bold,
fast sight picture in any lighting environment. The large, bright Tritium Dot provides a very effective low-light capability with the large green polymer ring around the dot provides an eye-catching daylight sight picture. Sight Post is precision machined from one piece of billet 416 Stainless Steel for durability and precise fit on all
Benelli and Beretta Tactical Shotguns. The included Blitzkrieg Components elevation spacers enable 3 height levels for the front sight post ensuring proper zero on any Benelli shotgun with aperture sights as well as the Beretta 1301 tactical shotguns. The Sight Hood is machined out of 7075 Aluminum and has a Mil-Spec Hard-Coat Anodized Finish.
Features:
- Bold, Fast Sight Picture
- Bright Tritium Dot with Bright Green Polymer Ring around Dot
- Billet Machined 416 Stainless Steel Construction
- Black oxide matte black finish
- Flat-Tipped Sight Profile
- Elevation Spacers to properly fit all Benelli Shotguns with this type of sight as well as Beretta 1301 shotguns
- Sight Hood with Serrated Rear Edge for the Ultimate Sight Picture
Fit: Blitzkrieg's New Elevation Spacer System allows one sight to fit all Benelli Ghost
Ring Sighted Shotguns as well as Beretta 1301 tactical shotguns (Benelli M4, M1014, Beretta 1301 Tactical, Benelli
M1, M2 Tactical, M3 Tactical, Nova Tactical, Super Nova Tactical)
Parts Included:
- Sight Post
- Sight Hood
- 2 Elevation Spacers
- Lock Nut
Drop-In Installation: To install, simply unscrew the
nut holding your factory sight post in place and remove it. Place the new Sight Post into the Sight Hood and place onto the sight base on the shotgun barrel. Then using
the lock nut supplied with the sight, secure the sight post and hood in its place. Tighten slightly with 5.5mm wrench to engage locking surface of the nut. 2 Stainless Steel Elevation Spacers are included to adjust sight height as needed by adding them to the bottom of the sight post. For the short sight height that is typical on Benelli M4 and Beretta 1301, no spacer is needed to match factory sight height. For other Benelli models that use a taller front sight, 2 spacers are used to match the factory sight height. If you desire to have your sight tip be at exact center of our front sight hood, use 1 spacer and adjust your rear sight accordingly. For super easy installation, get one of our 5.5mm wrenches (sold separately).
MADE IN THE USA
